Home page

4m plate shears

The operator of 4m plate shears should be familiar with the main structure, performance and use method of the plate shears

Category：

Shearing machine bending machine series

86-15028755418

haichijixie@163.com

Inquiry

Details

The operator of 4m plate shears should be familiar with the main structure, performance and use method of the plate shears

4m plate shears are suitable for cutting all kinds of steel plates, copper plates, aluminum plates and non-metallic material plates with a thickness of the rated value of the machine tool. They are materials without hard marks, welding slag, slag inclusions and welds, and excess thickness is not allowed

how to use the 4m plate shears: adjust the blade clearance according to the thickness of the material being sheared; Adjust the profiling or fixture according to the width of the sheared material; Before the operation of the plate shear, make 1-3 empty strokes first, and then implement the cutting work after it is normal

in case of abnormal operation of the machine during use, immediately cut off the power supply and stop the machine for inspection

4-meter plate shears use and operation matters:

1. Before work, carefully check whether all parts of the plate shears are normal, whether the electrical equipment is intact, and whether the lubrication system is smooth; Remove the sundries such as tools, measuring tools and corner waste materials placed on and around the table

2. Do not operate the plate shears by one person alone. Two to three people should coordinate the feeding, control the dimensional accuracy and reclaiming, and determine that one person should be in charge

3. Adjust the scissors clearance of the plate shears according to the specified thickness of the plate shears. It is not allowed to cut two kinds of plates with different specifications and materials at the same time; Stacking and shearing are not allowed. The cut sheet metal shall have a flat surface, and it is not allowed to cut narrow sheets that cannot be compacted

4. The belt, flywheel, gear, shaft and other moving parts of the plate shears should be installed with protective covers

5. The feeding finger of the plate cutter operator should be kept at a distance of less than 200mm from the scissors mouth and away from the pressing device. The protective fence placed on the cutting trigger shall not block the operator's eyes from seeing the cutting part. The waste produced after operation is angular, and the operator should remove it in time to prevent stabbing and cutting

6. The flywheel, gear, shaft, belt and other moving parts of the plate shears should be equipped with protective covers

7. Place a fence to prevent the operator's hand from entering the area where the scissors fall. It is strictly forbidden to pick up waste materials on the ground during work to avoid being injured by falling workpieces

8. Do not cut quenched materials, and never allow cutting beyond the working capacity of the shearing machine

Keywords:

Show details

Consult